Eastron SDM630MCT-ML - Setup Mode; Password Validation; Communication Address

SDM630MCT-ML User Manual V1.2
- 10 -
Exported active energy in kWh
Imported reactive energy in kVArh
Exported reactive energy in kVArh
3.4 Setup Mode
The meter’s settable parameters are password protected. By long pressing the 4th button “E”, the user can get into
the setup mode.
3.4.1 Password Validation
Press button and to enter password.
Long press button for password confirmation.
If an incorrect password is entered, the display will show “Err”. If the
password is correct, the unit will show the setup menu.
Password: default 1000
3.4.2 Communication Address
Communication address setup
Long press to enter the setup
3.4.2.1 Communication address modes(quantity) setup interface
The meter has two communication address modes:
1. Single communication address: there is only 1 address for the whole meter, and all channels use the
same communication address.