Eastron SDM630MCT-ML - CT2 Check; CT1 Setup

SDM630MCT-ML User Manual V1.2
- 13 -
Press button and to set the stop bits.
Long press button to confirm.
Option:1(default), 2
Only when the parity is set to NONE, the stop bits can be 2.
3.4.6 CT2 check
Check only, not settable.
Note：if the unit is 100mA input version, the CT2 check will show 0.1A.
3.4.7 CT1 setup
Long press button to enter the setup.
Press button and to choose the right channel (CH01-
CH04).
Long press button to enter the setup interface of CT1 of each
phase.
Choose the phase to be set
Press button and to choose the phase（L1, L2, L3）
Long press to enter the CT1 setup interface
CT1 setup interface
Press button and to set the CT1 value.
Long press to confirm.
CT1 range：1~9999 A, default 100 A