Eastwood 31639 - User Manual

Questions and Answers

K
Katherine EllisonAug 5, 2025
Why is my Eastwood Wheel Balancers showing poor performance?
- M
  medinacharlesAug 5, 2025
  Poor balancer performance in Eastwood Wheel Balancers can stem from several issues. Ensure the wheel is properly mounted and sufficiently tightened on the main shaft. Also, make sure that you are using the correct wheel balancing weights for the application. Verify that the appropriate “ALU” option is selected for the weight type and location. Clean any dirt, grease, or foreign matter from the wheel and tire. Inspect for damage and securely fasten the balancer to the floor. If any of these issues occur, follow the wheel mounting procedure to remount the wheel, tighten the wheel on the main shaft, follow the balancing procedure functions, clean the wheel and tire, inspect the wheel and/or tire for damage, and securely fasten the balancer to the floor.
K
Kimberly FullerAug 12, 2025
What to do if my Eastwood 31639 Wheel Balancers makes excessive noise?
- D
  dmillerAug 12, 2025
  Excessive or unusual noise and vibration in your Eastwood Wheel Balancers can occur if the wheel isn't properly mounted or sufficiently tightened on the main shaft. Damage to the wheel or tire, or the balancer not being securely attached to the floor, can also cause these issues. To resolve this, follow the wheel mounting procedure to remount the wheel, tighten the wheel on the main shaft, inspect the wheel and/or tire for damage, and securely fasten the balancer to the floor.
D
david23Aug 19, 2025
Why is the spin cycle slow on my Eastwood 31639?
- M
  mary35Sep 12, 2025
  If your Eastwood Wheel Balancers' spin cycle is slow to spool up or doesn’t reach full speed, it might be due to the wheel not being properly mounted or sufficiently tightened on the main shaft. Another potential cause is a slipping belt drive. To address these issues, follow the wheel mounting procedure to remount the wheel, tighten the wheel on the main shaft, or tighten the drive belt per the maintenance instructions.
S
smithchristianAug 27, 2025
What to do if wheel doesn't stop on Eastwood Wheel Balancers?
- J
  Justin WattsAug 27, 2025
  If the wheel on your Eastwood Wheel Balancers doesn’t stop immediately at the end of the spin cycle or when the STOP key is pressed, it could be due to the wheel not being properly mounted or tightened on the main shaft. A slipping belt drive can also cause this. You can fix this by following the wheel mounting procedure to remount the wheel, tightening the wheel on the main shaft, or tightening the drive belt according to the maintenance instructions.