Installation Instructions for
Universal Waterfall Diffusers
Thank you for purchasing the Eco-Series Universal Waterfall Diuser. You are about to experience the
Eco-Series
®
dierence in water feature products. The simple design of all Eco-Series
®
products provides
you with reliable, trouble-free installation and maintenance for all your water feature designs. This Universal
Waterfall Diuser is a fast and easy way to create professional looking waterfalls.
HOW IT WORKS...
Water enters the diuser and is depressurized. Water then ows over and
under the vertical dividers resulting in an even ow of water at the source
point. These diuser units are designed for ows up to 6000 gph from a
single end. By using both ends as inlets the UWD32 and UWD46 units can
handle higher ows.
STEP ONE
Insert the 2" male adapter into the desired port and tighten. Ideally silicone or Teon
tape is used on threads for water tight seal.
STEP TWO
Insert the threaded 2" plug into the unused port and tighten. When using dual
diusers both ends may need to have a male adapter for higher ow rates.
UWD23
25-100 gpm
23"w x 3
1
/
2
"t x 14" deep
UWD46
50-200 gpm
(over 100 gpm should be plumbed from both ends)
46"w x 3
1
/
2
"t x 14" deep
UWD16
16-66 gpm
16"w x 3
1
/
2
"t x 14" deep
UWD32
32-132 gpm
(over 100 gpm should be plumbed from both ends)
32"w x 3
1
/
2
"t x 14" deep
To Next Page
Need help?
General
