Perfect Fit Guide
Proper positioning is needed to achieve optimum standing posture.
Before transfering into the stander,
measure for approximate (A) seat
depth and seat to (B) foot plate set-
tings
step one - measure
Evolv & Glider
step two - seat depth
step three - back angle
Use the above measurement (A) to
adjust the seat depth on the stander.
To adjust seat depth, loosen the knob
under the seat (C). Depress the snap
button on the adjustment tube while
moving the back (D). Tighten the knob
after adjusting.
For the Evolv: Use measurement “A”
and measure from the front of the
seat to the back. Adjust the seat depth
until the proper measurement has
been reached.
For the Glider: Use measurement “A”
and measure from the center of the
kneepad to the back. Adjust the seat
depth until the proper measurement
has been reached.
(C)
(D)
After achieving your desired seat
depth, rotate the back angle (E) adjust-
ment knob so the (F) seat/back angle
indicator is in the green area prior to
standing.
Note: Repeat steps 2 and 3 for each
color adjustment.
(B)
(A)
over . . .
(F) (E)
444
www.easystand.com 800•342•8968
These adjustments are only to be made while the unit is in the seated position.
To Next Page
Need help?
General
