Eaton 9355-F47 Unirom - Page 48

INTERNAL BATTERY INSTALLATION
Eaton 9355-F47 Unirom UPS (10/15 kVA) User's Guide S 164201642 Rev C www.eaton.com/powerquality
42
16. Connect the wires from the electronics module (already routed to
the front of the UPS) to the battery terminals, as described below
(see Figure 22):
Connect the red connector from the electronics module to the red
connector from the top tray.
Route the remaining electronics module wire (with the black
connector) through the bushing to the bottom shelf. Connect the
black connector from the electronics module to the black connector
from the bottom tray.
Figure 22. Connecting the Battery Circuit Breaker Wires