Eaton 9355-F47 Unirom - Page 64

COMMUNICATION
Eaton 9355-F47 Unirom UPS (10/15 kVA) User's Guide S 164201642 Rev C www.eaton.com/powerquality
58
4. Route the cable(s) to the approximate location of the cover access
holes.
5. Connect the cables to the appropriate location.
See the following section, “Communication Options,” or “Control
Terminals” on page 68 for detailed information.
6. Reinstall the front covers, starting with the bottom cabinet (see
Figure 32).
Hang the top edge of the cover on the cabinet first, then lower the
bottom edge and snap into place. Be sure the cables fit in the
access holes in the covers.
Figure 32. Reinstalling the Front Covers
7. Continue to “Operation” on page 73 to start up the UPS.
Remove the lockout/tagout devices before starting up the UPS.