EasyManua.ls Logo

Eaton 9355 - Page 63

Eaton 9355
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Communication
Eaton 9355 UPS (20/30kVA) Installation and Operation Manual 164201626—Rev F www.eaton.com/powerquality 55
l
ConnectUPS
-X Web/SNMP Card - has SNMP and HTTP capabilities as well as monitoring through a Web
browser interface; connects to a twisted-pair Ethernet (10/100BaseT) network. It has a built-in switching hub
that allows three additional network devices to be connected to the network without the requirement of
additional network drops. In addition, a Environmental Monitoring Probe can be attached to obtain humidity,
temperature, smoke alarm, and security information.
l
Relay Interface Card - has isolated dry contact (Form-C) relay outputs for UPS status: Utility failure, Low
battery, UPS alarm/OK, or On bypass.
l
Modbus
®
Card - allows you to continuously and reliably monitor the UPSs in your Building Management
System (BMS).
l
Industrial Relay Card - is used to indicate the operating status of the UPS using the customer's monitoring
equipment and to connect an optional RMP. The IRC uses four isolated normally-open or normally-closed dry
relay contacts to indicate the UPS status. Normal, Bypass, Battery, and Alarm mode can be monitored (see
page 59 for more information).
l
Multi-Server Card - has six serial communication ports that can communicate simultaneously with other
computers using LanSafe Power Management Software (provided on the Software Suite CD).
l
Modem Card - provides out-of-band remote notification and monitoring using modem communication
directly to cell phones and pagers.
l
Single-Port Card - provides serial communication.
l
ConnectUPS-MX SNMP Card - has Ethernet, modem, and SNMP capabilities.
l
USB Card - connects to a USB port on your computer.
Note: The Eaton 9355 UPS does not detect plug-and-play hardware. Before installing the USB Card, set the
UPS baud rate to 1200 through the front panel (see Table 7 on page 70).
See Figure 36 on page 51 for the location of the two X-Slot communication bays.
Figure 41. Optional X-Slot Cards
Multi-Server Card
Modem Card
Single-Port Card
draCPMNSXM-SPUtcennoC
USBCard
Relay Interface Card
Modbus Card
ConnectUPS-X Web/SNMP Card
draCyaleRlairtsudnI
Power Xpert
®
Gateway Card

Table of Contents

Other manuals for Eaton 9355

Related product manuals