Eaton 9355 - Page 64

52 Eaton 9355 UPS (10/15 kVA) User’s Guide 164201594—Rev H0
Figure 37. UPS Rear View (3-High Shown)
Battery Circuit Breaker
UPS Wiring
Access Cover
Conduit Landing Plates
14. Hardwire the UPS input terminations.
See Table 6 for specifications and Figure 38 for a detailed view of the UPS terminal block.
NOTE 1 Input neutral must be wired for proper operation. Failure to connect an input neutral will
void the warranty. If the optional input transformer is installed, an input neutral is not
required.
NOTE 2 The Eaton 9355 UPS is a single-feed UPS only.
UPS System Installation