Eaton 93PR 500 kW UPS
User's and Installation Guide
54
There are three attempts to input the password. If an incorrect password is given more than three times,
you need to wait for 30 minutes before trying again. To modify the user settings, you need to enter level 2
password.For the default passwords, see Chapter
11
APPENDIX A: User settings.
Figure 6-3: Parts of the Touch Screen
Figure 6-4: Sign In or Password Request Screen
A
The UPS status area automatically displays the Eaton model number, current time and date, ac-
tive alarms, active notices, and load percent and battery run time for the UPS. If the Environmental
Monitoring Probe is installed, the temperature and humidity sensed by the probe will also be displayed.
The small head symbol between the system model and time allows the operator select a different language from
an imbedded list.
The top line of the display blinks while scrolling when the system needs attention. Some notices and alarms may
be accompanied by an audible horn. To silence the horn, touch anywhere on the control panel once. For more infor-
mation about alarms and notices, see Section
6.2.4
.
B
The information area contains data about UPS status and operations.
C
After touching the padlock in the upper right corner, the numerical keypad appears to allow entry of
the system access pass code for ooperation. See the following table
6-3
.
D
The padlock number indicates security level 0 - 3.
E
ENTER button.
To Next Page
Loading...
