Eaton 9910 - Display Information and Menu Navigation

OPERATION
Eaton 9910 UPS and EBM User's Guide S P-164000005 Rev 2
23
While any screen is displayed, press the escape (X) button until the main
menu is displayed, and then press the down (
B
) button to scroll through
the following main menu choices:
S System Status
S Alarm History
S Meters
S Control Screens
S Model Information
S Configuration
Press the OK button to select a menu item.
System Status
The System Status provides the following information:
S Battery status, including state and change level
S Status summary (load percentage, output power, output voltage and
frequency, and mode)
S Notice or alarm status, if any are present
If the message ALARM is displayed, press the down (
B
) button to
display the active notices, alarms, and battery status messages. For
more information, see Table 2 and Chapter 8, “Troubleshooting,” on
page 57.
Table 2 describes the available battery status messages. Only one
battery status is available at a time.
Table 2. Battery Status Messages
Battery Status Description
Battery charging Batteries are charged in constant current mode.
Battery floating Batteries are charged in constant voltage mode.
Battery resting Batteries are connected but are not being charged or discharged. (This is part of the
normal charging cycle.)
Battery discharging Batteries are discharging.
Battery disconnected Batteries are unavailable because they are disconnected.