Eaton 9A UPS - UPS Operation and Configuration; Front Panel Display and Controls

17
9A UPS 1-3K
4 Interfaces and communicaon
4.1 Display and Buons
The screen provides useful information about the UPS input, output, load, setting and fault
information.
The following table shows the descripon of LCD buon:
Switch Funcon
ON-Buon
Turn on UPS system: By pressing the “ON” button, the UPS system is turned on.
Deacvate acousc alarm: By pressing this buon an acousc alarm can be deacvated in the
baery mode. By short touch this Buon all acousc alarms can be deacvated in all mode.
Do the baery test: By pressing this Buon the UPS can do the baery test in the Line mode
or ECO mode or Converter mode.
OFF-Buon
When mains power is normal, the UPS system switches to No output or Bypass mode by
pressing “OFF” buon , and the inverter is o. At this moment, if Bypass is enabled, then
the output sockets are supplied with voltage via the bypass if the mains power is available.
Deacvate acousc alarm: By pressing this buon an acousc alarm can be deacvated in
the bypass mode.
Release the UPS from fault mode and EPO status.
Select-Buon The output voltage, frequency, Bypass disable/enable and operating mode in No output or
Bypass mode, The number of EBM in all mode, could be selected by pressing Select-Button,
and confirmed by pressing Enter-Button.Enter-Buon
Hz
Vac
Hz
Vac
+
OUTPUT LOAD
INPUT BATTERY