Eaton 9E10Ki - Page 24

21
1. Use a 2x0.75mm
2
cable to make the connection with the R.E.P.O.
terminals.
2. Insert the screw driver in the square hole and press down to make the
round hole terminal open. Then insert the wire into the round hole. Then
pull out the screw driver. Connect the two wires of the cable to terminals
5 and 6 (for version 9E6Ki), 7 and 8 (for versions 9E10Ki, 9E10KiXL,
9E15Ki, 9E15KiXL, 9E20Ki, 9E20KiXL) to be able to remotely shut off
the UPS.
9E6Ki
9E10Ki, 9E10KiXL, 9E15Ki,
9E15KiXL, 9E20Ki, 9E20KiXL
Fig.3-7 EPO terminal connection
3. Close the backpanel cover and secure it with the screws taken out
earlier.