Eaton 9PX - User Settings (Continued)

Eaton 9PX Lithium-Ion User Guide P-164001006—Rev 02 11
Table 6. User Settings (Continued)
Submenu Available Settings Default Settings
- [Delay]: [0s] … [999s] [0s]
- [Active]: [High] [Low] [High]
Output Signals
[Relay] [DB9-1] [DB9-7] [DB9-8] Sets events or
fault that will actuate Output signal parameters
through external contact connector or RS232
[Relay]: [On bat] [Low bat] [Bat fault] [Bypass] [UPS
OK] [Load protected] [Load powered] [General
alarm] [Ext. charger ON] [OVL pre-alarm]
[Relay] [Bypass]
[DB9-1]: [On bat] [Low bat] [Bat fault] [Bypass]
[UPS OK] [Load protected] [Load powered] [General
alarm] [Ext. charger ON] [OVL pre-alarm]
[DB9-1] [Low bat]
[DB9-7]: [On bat] [Low bat] [Bat fault] [Bypass]
[UPS OK] [Load protected] [Load powered] [General
alarm] [Ext. charger ON] [OVL pre-alarm]
[DB9-7] [UPS OK]
[DB9-8]: [On bat] [Low bat] [Bat fault] [Bypass]
[UPS OK] [Load protected] [Load powered] [General
alarm] [Ext. charger ON] [OVL pre-alarm]
[DB9-8] [On bat]
Remote command
[Enabled] [Disabled] If Enabled, shutdown or
restart commands from software are authorized.
[Enabled]
Shutdown commands
[Send CMD] [Output OFF] [OFF delay] [restart]
Sets events or fault that will actuate Output signal
parameters through external contact connector or
RS232 port
[Send CMD]: [Yes] [No] Send CMD: [No]
[Output OFF]: [No] [UPS] [Group 1] Output OFF: [No]
[Group 2] [Group 1 + Group 2]
[OFF delay]: [0s] …[999s] OFF delay: [0s]
[Restart]: [Yes] [No] Restart: [Yes]
On battery notice delay
[0s] ... [99s] [0s]
Sets delay before noticing on battery information
to software.
General alarm
[On battery] [Battery fault] [Internal fault]
[Overload pre-alarm] [Internal fault]
[Ambient temp.] [Fan lock]
[Bypass overload] [Current limit]
[Short circuit] [Inverter overload]
[Power overload] [Low battery]
User Settings