Eaton 9PXM - Figure 69. Comm Settings Menu

4–20kVA Users Guide P-164000669 4–20kVA Users Guide P-164000669—Rev 09 87
Comm Settings
The Comm Settings Menu enables/disables some selected control signal features.
Figure 69. Comm Settings Menu
Local Settings
In/Out settings
On/Off settings
Battery settings
Input signals
Comm settings
User password enable
User password settings
Settings
Minislot 1 remote off
Enabled √
Disabled
Enabled √
Disabled
Remote command
Enabled √
Disabled
Battery notice delay
s
0
Comm Settings
Go to bypass
Start battery test
Reset fault state
Restore factory set
Minislot 1 reset
No
Ye s
Are you sure?
Go to bypass
Start battery test
Reset fault state
Restore factory set
No
Ye s
Are you sure?
Minislot 2 reset
Minislot 1 remote off
Remote Command
Shutdown command
Battery notice delay
Comm Settings
Com Settings
Send command √
Output off √
Off delay 10s
Output off √
Minislot 2 remote off
Minislot 2 remote off
Comm Settings
Minislot 2 reset
Minislot 1 reset
ABM On Off
Minislot 2 remote off
Remote command
Shutdown command
Battery notice delay
Minislot 1 reset
Minislot 2 reset
Battery settings
Minislot 1 remote off
[Yes] [No]
[Yes] [No]
[0s] ... [99s]
Sets delay before displaying
on battery information
to software..
Default Value: [0s]
Default Value: [Enabled]
Default Value: [Enabled]
[Enabled] [Disabled]
If Enabled, shutdown or restart
commands from software are
authorized.
Default Value: [Enabled]
[OFF delay][Restart]. Sets events
or fault that will actuate Output
signal parameters through
external contact connector or
RS232 port
[Send CMD]: Select [ ] [Unselect]
[Output OFF]: Select [ ] [Unselect]
[OFF delay]: [0s] …[999s]
[Restart]: [Yes] [No] authorized.
Default Values:
Send CMD: [Unselect]
Output OFF: Select [ ]
Restart: Select [ ]
√
√
√
√
Display Menu Screens