Eaton BladeUPS Series - Tools

4 Eaton BladeUPS DoS Installation Instructions P-164000613—Rev 3
Figure 2. BladeUPS Shipping Carton
Section 2 Tools
To assemble the components, you may need the following tools:
l
Forklift or pallet jack
l
Flathead (short and long)
l
Short- and long-handled medium flat-bladed screwdriver
l
Short- and long-handled #2 Phillips® screwdriver
l
Ratcheting socket wrench and socket for 9/16" screws
l
7 mm wrench or socket
l
Utility knife
l
Adjustable pliers
2 Two-screw Brackets
2 Ferrite Cores
1 package Assorted jumpers for REPO (see the standard
BladeUPS manual)
May include 2-pin or 3-pin jumpers
Table 1. Shipped in Each Shipping Carton (Continued)
Quantity Description