Eaton BladeUPS Series - CAN Bridge Card Cable Connection

Eaton BladeUPS DoS Installation Instructions P-164000613—Rev 3 15
CAN Bridge Card Cable
a. Install a CAN Bridge Card cable between the UPSs, connecting the CAN OUT port (on the top UPS) to
the CAN IN port (on the bottom UPS). See Figure 17.
Figure 17. CAN Bridge Card Connections
X-slot BAY = Hot Sync CAN Bridge Card
CAN OUT = Blue Terminating Plug
CAN IN = CAN Bridge Card Cable
X-slot BAY = Hot Sync CAN Bridge Card
CAN IN = Blue Terminating Plug
CAN OUT = CAN Bridge Card Cable
TOP UPS
BOTTOM UPS