2 Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14
• 6U height that fits any standard 19-inch rack (see Figure 2)
• Normal operating mode that minimizes heat generation by operating typically at >98% efficiency. The UPS
filters incoming AC power and provides consistent power to your equipment without draining the battery.
• For utility line input that exceeds normal operating range, automatic transfer to an online, double-
conversion, high-frequency UPS design with pure sine wave output and power-factor correction.
• ABM
®
technology that uses advanced battery management to increase battery service life, optimize
recharge time, and provide a warning before the end of useful battery life.
• Hot-swappable electronics module and batteries that simplify maintenance by allowing you to replace
them safely without powering down the critical load.
• Emergency shutdown control through the remote emergency power-off (REPO) port.
• One standard communication option with a DB-9 serial port and two open communication bays (X-Slot)
that allow a number of communication options.
• Firmware that is service upgradable through the DB-9 communication port.
Figure 2. Standard Cabinet Used for BladeUPS
Introduction
To Next Page
Loading...
