Eaton BladeUPS - Page 17

Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14 3
NOTE The illustrations in this document are typical, but may not be identical to your model.
• Backed by worldwide agency approvals.
• The following accessories for the BladeUPS are available:
• Eaton® BladeUPS® Maintenance Bypass Module (MBM) to safely service the UPS without disrupting
power.
• External Battery Interconnect to connect a customer-supplied external battery to the UPS for extended
runtime.
• EBM for extended runtime.
NOTE Install up to four EBMs per UPS. Each EBM includes a 0.9m (3 ft) connector cable. A
0.9m (3 ft) battery extension cable is also available.
• X-Slot® cards with enhanced communication capabilities for network connectivity with monitoring and
control.
The BladeUPS Bar for parallel systems, mounted in the rear of an Eaton rack, provides the required input
and output connections for the paralleled UPSs and has system-rated input and output connections. Figure
3 shows an example of a BladeUPS parallel system.
The BladeUPS system can be installed with Eaton remote power panels, transformer cabinet with bypass
and distribution, and rack-mounted power distribution systems.
Introduction