Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14 25
NOTE There is a front and a rear stabilizing bracket to secure the system for shipping. The
brackets are bolted both to the pallet and the cabinet. The bolts must be removed
before unloading the system.
1. Remove the four shipping bolts securing the front stabilizing bracket (see Figure 8).
2. Remove the four shipping bolts securing the rear stabilizing bracket.
3. Remove the brackets.
Figure 8. Removing the Stabilizing Brackets
Pallet Rear
Four
Shipping
Bolts
Bracket
4. If the leveling feet are not fully retracted, turn the leveling feet clockwise until they are retracted (see
Figure 9 ).
Unloading the System
To Next Page
Loading...
