Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14 33
Figure 14. Removing the Trim Screws
Interior Trim Screws
Outside Trim Screws
(A, B, C, D)
Top Panel Trim
(1−8)
1
2
3
4
5
6
7
8
A
B
C
D
NOTE Each top panel trim has three pieces, but do not disassemble it. It is attached as one
assembly.
4. Use a ratcheting socket wrench with a 3/8-inch socket or a screwdriver to loosen the bolts that secure the
cabinet top panel.
• Locate the five top panel bolts inside the rack. Three bolts are located at the front of the rack and two
bolts are at the back of the rack.
• Loosen the bolts, but do not remove them. Leave them protruding about 1/8 inch.
Top Entry Installation
To Next Page
Loading...
