Eaton Box 1 - Box 1 Starter;Contactor Mounting Locations

14
Instructions and Operation P52899
Effective July 2019
Box 1 and Box 2 non-combination enclosed
control and C600M cover control kit wiring
EATON www.eaton.com
Box 1 starter/contactor mounting locations
Box 1 mounting locations
D
A
A
A
B
B
C
Box 1 mounting location example
D
A
A
A
B
B
C
Example: If you want to mount a AN16AN, you would put the top
hole in the 14B location.
Table 1. Box 1 mounting locations
Family Starter/contactor Size Top location
ECN
ECN01 CN15AN 00 1
CN15BN 0 1
CN15DN 1 1
CN15GN 2 1
ECN02 CN55AN 00 1
CN55BN 0 1
ECN05 AN16AN 00 14B
AN19AN 00 14B
AN16BN 0 14B
AN19BN 0 14B
AN16DN 1 14A
AN19DN 1 14A
AN19GN 2 14A
ECL
ECL03 CN35AN 2–4 P 1
CN35BN 2–4 P 1
CN35DN 2–3 P 1
CN35GN 2–4 P 1
DP
DP A25/B25 15–30 A 14A
A27/B27 15–45 A 4A
ECX
ECX09 XTCE B 2C
XTCE C 2E
ECX10 XTCR B 2D, 2B
XTCR C 2A, 2C
otes:N All indicated mounting holes represent contactor or starter top or top
left mounting location. Additional screws are required for full contactor or
starter assembly.
Cover control bracket mounting holes are on the far right of the base.
Letters are not stamped in the box.