Eaton Bussmann Series - Interlocking Door and Switch; Padlocking the Handle

10
Installation manual 3A3718 Rev E
Effective February 2019
CCP2-H4X-_ pistol handles for 12 mm shafts
Eaton.com/bussmannseries
Left side counterclockwise
handle operation and
installation
The following applies to all
counterclockwise operating handles.
Procedures for counterclockwise
handle catalog numbers:
•
CCP2-H4X-B3L (short)
•
CCP2-H4X-R3L (short)
•
CCP2-H4X-B4L (long)
•
CCP2-H4X-R4L (long)
For installation with switch catalog
numbers:
•
CCP2-(poles)-200CF
•
CCD2-3-200
•
CCP2-(poles)-400CF
•
CCD2-3-400
And requires installation of:
•
The side rotary mechanism:
• CCP2-SM mounted on the switch’s
left side
•
Either shaft catalog numbers:
• CCP2-SH2-225
• CCP2-SH2-425
OFF
ON
OFF
Switch operating modes
NOTE: Side installation
(handle mounted on the
enclosure’s side and not
the door) does NOT provide
for an interlock means to
prevent opening the door
while the switch is in either
the ON or OFF position.
If preventing access to
the enclosure’s interior is
desired or required by the
application, use a locking
door latch or install a suitable
hasp to accept a lock.
ON
OFF
X
X
Handle lock ON and OFF operation
Note: Lock “ON” NOT to be utilized when switch is applied as a means for emergency stop.
The counterclockwise rotating handles are factory configured for both lock ON and lock OFF.
To lock the switch, simply rotate the handle to the desired switch state (ON or OFF), depress the
switch locking mechanism and insert up to three 1/4” locks.