Eaton CEAG DualGuard-S - Page 53

148 pages

To Next Page

To Previous Page

Mounting- and Operating Instruction CEAG DualGuard-S 40071860347 January 2020 www.ceag.de

20 ACU DG Modul

Main Page

Default Chapter2
- Table of Contents2
1 Important Notes4
- Symbol Key4
- Information on the Operating Manual4
- Applicable Documents4
- Liability and Warranty4
- Copyright4
- Spare Parts4
- Disposal4
- Safety5
- Intended Use5
- Contents of the Operating Manual5
- Modifying and Retrofitting the Equipment5
- Responsibility of the Operator5
- Occupational Safety6
- Personal Protective Equipment6
2 Transportation, Packaging and Storage of Batterys6
- Safety Notes6
- Transport over Land, Enclosed Lead Battery Blocks6
- Transportation of Enclosed Lead Batterys by Sea6
- Transportation of Enclosed Lead Batterys by Air6
- Abbreviations6
- Transport Inspection7
- Packaging7
- Requirements and Prep7
- Storage Conditions7
- Storage7
- Storage Time7
3 Set up and Installation8
- Battery Rooms, Ventilation and General Requirements8
- Temperature8
- Room Dimensions and Floor Condition9
- Ventilation Requirements9
4 Preparations for Battery Installation10
- Mounting Battery Blocks and Battery Block Sensors10
- Battery Sets in Parallel Installations10
- Mounting Positions for AGM Blocks11
- Operation11
- Maintenance11
- General and Controls11
- Störungen12
- Spare Parts12
- Ordering Spare Parts12
5 Transport, Packaging and Storage12
- Transport Inspection12
- Packing12
- Storage13
6 Assembly and Installation of the Dualguard-S13
7 Installation Example Dualguard-S19
8 Block Diagram Dualguard-S20
9 Commissioning and Further Work21
10 Luminaire Addressing21
11 Checking the Wiring21
12 Voltage Measurements21
13 Insulation Measurement21
14 Check the Fuses of the Mains or Battery Power Supply22
15 Switching on the System23
16 Device Configuration23
17 General Product Description Dualguard-S48
18 Overview of Assemblies50
- HMI Color Touch Screen 4,3" and 750
19 HMI Color Touch Screen 4,3“ and 7“52
20 ACU DG Modul52
21 PSU Module58
22 AC Module59
23 BCM.1 Module60
24 CM.1 1,7 a Lademodule63
900 CM 3,4 a Lademodule63
26 Circuit Change over Module SKU.1.1 CG-S 4X1,5A64
27 Circuit Change over Module SKU.1.1 CG-S 2X3A65
28 Circuit Change over Module SKU.1.1 CG-S 1X6A66
29 Circuit Change over Module SOU CG-S 2X4 a67
30 CG IV.1 Relay Module68
31 CG V.1 Relay Module69
32 F3-Remote Control AP and up70
- 33 3-PM Module71
- 34 3-PM-IO Module72
- 35 3-PM-IO-INV Module73
36 Dualguard-S 2876
37 Dualguard-S 2076
38 Connection Distributor Mains80
39 Connection Distributor Battery81
40 Dualguard-S LAD 10082
41 Dualguard-S 12C96
42 Dualguard-S 12C6102
43 Dualguard-S 20C6104
44 Dualguard-S 12C4110
45 Dualguard-S 4C3114
46 Dualguard-S US38118
47 Dualguard-S US30120
48 Dualguard-S US 23120
49 Dualguard-S US 15124
50 Dualguard-S US 7126
51 Dualguard-S US SOU2128
52 Dualguard-S US SOU1129
53 Dualguard-S ESF30 US 15P130
54 Dualguard-S ESF30 US 30P131
55 Dualguard-S ESF30 US SOU5132
56 Dualguard-S ESF30 US SOU3133
57 Dualguard-S ESF30 US SOU2134
58 Dualguard-S ESF30 US SOU1135
59 Eaton CCOE Cybersecurity Recommendations136
Appendix A: Overview of Pin Assignments139
Appendix B: Overview of Pin Assignments140
Appendix D: Position Plans of the Luminaires141
Appendix E: Installation Examples Monitoring Modules142
Appendix F: Test and Inspection Protocol for Emergency Lighting Systems143
- General Safety Instructions - Batterys144

Eaton CEAG DualGuard-S - Page 53

Table of Contents

Related product manuals