67
Technical Data PR202-50-502-22
Effective June 2017
CF2000 System
EATON www.eaton.com
Internal Wall Sounder CAS381, CASB383
To install the device, fix to mounting surface using two suitable
screws. The rear gasket fits underneath the base and the sounder
gasket fits inside the base.
Connect the device as shown in Figure 46.
WARNING
DO NOT USE HIGH VOLTAGE TESTERS IF ANY EQUIPMENT
IS CONNECTED TO THE SYSTEM. EARTH SCREEN MUST BE
CONTINUOUS ALONG ENTIRE LENGTH OF LOOP.
Figure 46. Internal Wall Sounder CAS381
Note: Care should be taken to ensure that the cable does not put
stress on the circuit board
To Next Page
Loading...
