70
Technical Data PR202-50-502-22
Effective June 2017
CF2000 System
EATON www.eaton.com
1 Channel Mains Rated I/O
Wiring CMIO353
To install the device
1. Separate the two halves of the unit.
2. Drill out (or knock out) the required cable entries in the surface
mounting backbox.
3. Fit the back-box in position and pass the wires into it.
4. Connect the unit according the diagram in Figure 49.
ote:N
No addressing of the interface is required. See control panel
operation for details.
Figure 49. 1 Way Input Output Unit CMIO353
otes:N :
1. Only connect cable screen to its adjacent earth terminal.
2. The end of line resistor must always be fitted, even if the spur
is unused.
To Next Page
Loading...
