74
Technical Data PR202-50-502-22
Effective June 2017
CF2000 System
EATON www.eaton.com
Spur Isolator CSI350
To install the device
1. Fit the unit in position.
2. Connect the unit according to the diagram below.
otes:N
1. A Spur Isolator must be used when making spurs from the
analogue addressable panel loop. Without this unit, the self
addressing features of the system will not function correctly.
2. No addressing of the interface is required. See control panel
operation for details.
The standard connections are shown in Figure 53.
Figure 53. Spur Isolator CSI350
otes:N
1. Only connect cable screen to its adjacent earth terminal.
2. For maximum spur length / load see BS5839 Part1:2002.
3. This unit can only be used with Eaton CAB300 detector bases
and compatible sensors.
To Next Page
Loading...
