75
Technical Data PR202-50-502-22
Effective June 2017
CF2000 System
EATON www.eaton.com
4 Way Sounder Controller CSC354CPR
To install the device
1. Remove the cover of the unit.
2. Fit the back-plate in position and pass the wires into it taking
care not to damage the circuit board.
3. Connect the unit according to the diagram below.
ote:N No addressing of the interface is required. See control panel opera-
tion for details. This unit requires a permanent 230V AC supply.
The standard connections are shown in Figure 54.
Figure 54. 4 Way Sounder Controller CSC354CPR
otes:N
1. Only connect cable screen to its adjacent earth terminal.
2. The end of line resistors must always be fitted, even if the
sounder circuits are unused
To Next Page
Loading...
