Eaton Char-Lynn - Disassembly

6
EATON Char-Lynn Delta Motors Parts and Repair Manual C-MOLO-TS003-E September 2007
Step 1
Position the housing in the
vertical position on a clean
smooth surface, use shell bearing
tool No. 606253 and press the
shell bearing into position in the
housing. The lettering on the
bearing race denotes the side
to be contacted by the tool.
Step 2
Lubricate the grease seal with
Mobilux EP 111 and press it into
position in the housing with tool
No. 606254.
Step 3
Flip housing. Install back-up
washer into interior bore of the
housing. Lubricate the shaft
seal lip with Mobilux EP 111,
place on assembly tool No.
600421-2 and press it into the
interior bore of the housing.
Reassembly
DeltaPartManual_v7.qxd:HydraulicsTech.qxd 9/19/07 11:40 AM Page 6