Eaton Crouse-hinds series - System Settings; System Settings: Auto Detect; System Settings: View Menu

39
INM MTL SUM5 Rev 7
DRAFT - 09 June 2021 DRAFT - 09 June 2021
17 SYSTEM SETTINGS
17.1 Auto Detect
The user is able to Auto Detect the congurations of an existing SmartAlarm once they
have loaded the SmartAlarm conguration software onto a suitable PC and connected
the USB Cable to the communication port located behind the rubber bung on the front of
the SmartAlarm.
The auto detect facility is accessed via the “File” menu as shown above.
Once selected all of the settings stored within the SmartAlarm are read into the software
allowing the user to view, save or modify the conguration as required.
17.2 View
The following settings are available under the “View” menu.