Eaton CSAU-01/02 - User Manual

Technical Data / Technische gegevens / Tekniske data / Technische Daten / Technická data
CSAU-01/02 CEMU-01/03
Power supply 230 VAC +10% -15%, 50 Hz Power supply 230 VAC +10% -15%, 50 Hz
Load 230VAC, 50Hz, 8A
Resistive; 24VDC 8A
Measure range 15W < x < 23kW
(max 100A)
Dimensions 48.6 x 45.3 x 26.2 mm (H x W x D) Accuracy 10%
Dimensions 48.6 x 45.3 x 26.2 mm (H x W x D)
CSAU-01/02
Switching
actuator
CEMU-01/03
Energy sensor,
external sensor
868.3 MHz
IP20
MRF
Version 2.60
SHC-RF Version 2.21
ECI-RF Version 2.00
USB-RF
Version 2.00
Required - Må - Vereist - Erforderlich - Povinný
(not included) - (ikke inkludert) - (niet inbegrepen) - (nicht enthalten) - (není v ceně)
CHCA-00/01
Smart Home Controller
xChargeIn X, S or M type
Electrical Vehicle Charging
xChargeIn without key switch, and with RFID disabled
xChargeIn uten nøkkelbryter, og med RFID deaktivert
xChargeIn zonder sleutelschakelaar, en met RFID gedeactiveerd
xChargeIn ohne Schlüsselschalter und mit RFID deaktiviert
xChargeIn bez klíčového spínače a bez RFID
SHC - xChargeIn Peak Control
CPAD-00/219
Hurtig installasjon kort - Snelle installatiekaart - Schnellinstallationskarte - Karta pro rychlou instalaci
Quick Installation Guide
1
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria MA-SHC_xChargeln.indd / 07.2018a / IL019220ZU / 136211201
© 2018 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation All Rights Reserved / Printed in Austria
www.eaton.com/recycling

Eaton CSAU-01/02 Specifications

General

Phase	Single-Phase
Nominal Discharge Current (In)	20kA
Maximum Discharge Current (Imax)	40kA
Response Time	< 25ns
Enclosure Rating	NEMA 4X
Connection Type	Hardwired
Wire Size	14-6 AWG
Accessory Type	Surge Protective Device
Voltage	120/240V
Voltage Rating	120/240 V
Maximum Continuous Operating Voltage (MCOV)	150 V
Standards	UL 1449 4th Edition
Type	Type 2

Summary

Connect xChargeln

Connect Energy Sensor

MRF Configuration

Connection List Configuration

Configure connected devices, zone information, and zone assignment in the MRF software.

Zone Management

Add, remove, or rename zones for device management within the MRF system.

SHC Configuration

Peak Control Setup

Configure Peak Control functions including status and control for power consumption.

Peak Shaving Macros

Set up macros for Peak Shaving using events and actions based on load power.