Eaton Cutler-Hammer FP-5000 - Page 66

IL17569
Page 5-18
Effective June, 2001
Table 5.6 Output Configuration Settings Phase time overcurrent (51P) and instantaneous (50P-1 & 50P-2) device settings
Display Setting Description Setpoint Range/ Default Selected Refer to
Value Selection Setting Value Sec. #
Output Trip1 Output Trip1 Relay Settings 5.5.6
Monitor: Select “Breaker Trip” coil circuit Off or On On
9.2
monitoring to on or off
9.6
Function: Select logic output function OR, AND, NOR, OR
for Output Trip1 NAND, Disable
Dropout: Select relay state after trip occurs Latched, Unlatched, Off Delay
or Off Delay
Off Delay (c): Select delay for Trip Relay 0 to 60 cycles 5
to dropout after trip event clears1 (1 cycle increments)
IN1: Select logic input IN1 * See Logic Input Options Trip
for Output Trip1 Table 5.10 AllProt
IN2: Select logic input IN2 * See Logic Input Options Cntrl,
for Output Trip1 Table 5.10 OpenBkr
IN3: Select logic input IN3 * See Logic Input Options Unused
for Output Trip1 Table 5.10
IN4: Select logic input IN4 * See Logic Input Options Unused
for Output Trip1 Table 5.10
Output Trip2 Output Trip2 Relay Settings 5.5.6
Monitor: Select “Close” coil Off or On Off
9.2
circuit monitoring to on or off
9.6
Function: Select logic output function OR, AND, NOR, Disabled
for Output Trip2 NAND, Disable
Dropout: Select relay state after Latched, Unlatched, Unlatched
trip occurs or Off Delay
Off Delay (c): Select delay for Trip 2 Relay 0 to 60 cycles 0
to dropout after trip event clears (1 cycle increments)
IN1: Select logic input IN1 * See Logic Input Options Unused
for Output Trip2 Table 5.10
IN2: Select logic input IN2 * See Logic Input Options Unused
for Output Trip2 Table 5.10
IN3: Select logic input IN3 * See Logic Input Options Unused
for Output Trip2 Table 5.10
IN4: Select logic input IN4 * See Logic Input Options Unused
for Output Trip2 Table 5.10
1 This setting is only used if the “Dropout” setting is set to “Off Delay.”