Eaton Cutler-Hammer FP-5000 - Page 67

Page 5-19
IL17569
Effective June, 2001
Table 5.6 Output Configuration Settings (continued)
Display Setting Description Setpoint Range/ Default Selected Refer to
Value Selection Setting Value Sec. #
Output Rly3 Output Relay 3 Settings 5.5.6
Function: Select logic output function OR, AND, NOR, OR
9.2
for Output Rly3 NAND, Disable
9.6
Dropout: Select relay state Latched, Unlatched, Latched
after trip occurs or Off Delay
Off Delay (C): Select delay for Relay to 0 to 60 cycles 0
dropout after trip event clears1 (1 cycle increments)
IN1: Select logic input IN1 * See Logic Input Options Trip, BF
for Output Rly3 Table 5.10
IN2: Select logic input IN2 * See Logic Input Options Unused
for Output Rly3 Table 5.10
IN3: Select logic input IN3 * See Logic Input Options Unused
for Output Rly3 Table 5.10
IN4: Select logic input IN4 * See Logic Input Options Unused
for Output Rly3 Table 5.10
Output Rly4 Output Relay 4 Settings 5.5.6
Function: Select logic output function OR, AND, NOR, Disabled
9.2
for Output Rly4 NAND, Disable
9.6
Dropout: Select relay state after trip occurs Latched, Unlatched, Unlatched
or Off Delay
Off Delay (C): Select delay for Relay to 0 to 60 cycles 0
dropout after trip event clears1 (1 cycle increments)
IN1: Select logic input IN1 * See Logic Input Options Unused
for Output Rly4 Table 5.10
IN2: Select logic input IN2 * See Logic Input Options Unused
for Output Rly4 Table 5.10
IN3: Select logic input IN3 * See Logic Input Options Unused
for Output Rly4 Table 5.10
IN4: Select logic input IN4 * See Logic Input Options Unused
for Output Rly4 Table 5.10
1 This setting is only used if the “Dropout” setting is set to “Off Delay.”