Eaton Cutler-Hammer FP-5000 - Page 68

IL17569
Page 5-20
Effective June, 2001
Table 5.6 Output Configuration Settings (continued)
Display Setting Description Setpoint Range/ Default Selected Refer to
Value Selection Setting Value Sec. #
Output Rly5 Output Relay 5 Settings 5.5.6
Function: Select logic output function OR, AND, NOR, OR
9.2
for Output Rly5 NAND, Disable
9.6
Dropout: Select relay state after trip occurs Latched, Unlatched, Off Delay
or Off Delay
Off Delay (C): Select delay for relay to 0 to 60 cycles 10
dropout after trip event clears1 (1 cycle increments)
IN1: Select logic input IN1 * See Logic Input Options Breaker,
for Output Rly5 Table 5.10 Close Bkr
IN2: Select logic input IN2 * See Logic Input Options Unused
for Output Rly5 Table 5.10
IN3: Select logic input IN3 * See Logic Input Options Unused
for Output Rly5 Table 5.10
IN4: Select logic input IN4 * See Logic Input Options Unused
for Output Rly5 Table 5.10
Output Alarm Output Alarm Relay Settings 5.5.6
Function: Select logic output function OR, AND, NOR, OR
9.2
for Output Alarm Relay NAND, Disable
9.6
Dropout: Select relay state after trip occurs Latched, Unlatched, Unlatched
or Off Delay
Off Delay (C): Select delay for relay to 0 to 60 cycles 0
dropout after trip event clears1 (1 cycle increments)
IN1: Select logic input IN1 * See Logic Input Options Trip, All
for Output Alarm Relay Table 5.10 Prot
IN2: Select logic input IN2 * See Logic Input Options Trip, All
for Output Alarm Relay Table 5.10 Alm
IN3: Select logic input IN3 * See Logic Input Options Sys Alm,
for Output Alarm Relay Table 5.10 All Alm
IN4: Select logic input IN4 * See Logic Input Options Breaker,
for Output Alarm Relay Table 5.10 All Alm
Output Aux LED Output Auxiliary LED Settings 5.5.6
Function: Select logic output function OR, AND, NOR, OR
9.2
for Output Aux LED NAND, Disable
9.6
IN1: Select logic input IN1 * See Logic Input Options Unused
for Output Aux LED Table 5.10
IN2: Select logic input IN2 * See Logic Input Options Unused
for Output Aux LED Table 5.10
IN3: Select logic input IN3 * See Logic Input Options Unused
for Output Aux LED Table 5.10
IN4: Select logic input IN4 * See Logic Input Options Unused
for Output Aux LED Table 5.10
1 This setting is only used if the “Dropout” setting is set to “Off Delay.”