Eaton Cutler-Hammer FP-5000 - Page 70

IL17569
Page 5-22
Effective June, 2001
Table 5.7 Programmable Logic Phase time overcurrent (51P) and instantaneous (50P-1 & 50P-2) device settings
Display Setting Description Setpoint Range/ Default Selected Refer to
Value Selection Setting Value Sec. #
Logic Gate 1 Logic gate 1 Settings 5.5.7
9.3
Function: Select logic function to apply OR, AND, NOR, Disable 9.6
to logic gate NAND, Disable
Set Group: Select protection setting group 1, 2, 3, 4 or All 1
for logic gate to apply
IN1: Select logic type for logic input 1 * See Logic Input Options Unused
Table 5.10
IN2: Select logic type for logic input 2 * See Logic Input Options Unused
Table 5.10
IN3: Select logic type for logic input 3 * See Logic Input Options Unused
Table 5.10
IN4: Select logic type for logic input 4 * See Logic Input Options Unused
Table 5.10
Logic Gate 2 Logic gate 2 Settings 5.5.7
9.3
Function: Select logic function to apply OR, AND, NOR, Disable 9.6
to logic gate NAND, Disable
Set Group: Select protection setting group 1, 2, 3, 4 or All 1
for logic gate to apply
IN1: Select logic type for logic input 1 * See Logic Input Options Unused
Table 5.10
IN2: Select logic type for logic input 2 * See Logic Input Options Unused
Table 5.10
IN3: Select logic type for logic input 3 * See Logic Input Options Unused
Table 5.10
IN4: Select logic type for logic input 4 * See Logic Input Options Unused
Table 5.10
Logic Gate 3 Logic gate 3 Settings 5.5.7
9.3
Function: Select logic function OR, AND, NOR, Disable 9.6
to apply to logic gate NAND, Disable
Set Group: Select protection setting group 1, 2, 3, 4 or All 1
for logic gate to apply
IN1: Select logic type for logic input 1 * See Logic Input Options Unused
Table 5.10
IN2: Select logic type for logic input 2 * See Logic Input Options Unused
Table 5.10
IN3: Select logic type for logic input 3 * See Logic Input Options Unused
Table 5.10
IN4: Select logic type for logic input 4 * See Logic Input Options Unused
Table 5.10