6 Parameters
DC1 Frequency Inverter 10/12 MN04020003Z-EN www.eaton.com 101
P-37 165 ✓ rw 0 - 9999 Access code definition 101
Used to define the access code that must be entered into P-14 in order
to get access to the parameters higher than P-14.
P-38
166 ✓ rw Parameter access lock 0
0 Deactivated
All parameters will be accessible and can be edited.
1 activated
Parameter values can be shown, but cannot be edited.
P-39
167 ✓ rw Offset for analog input 1 0.0
-500.0 - +500.0 %
Used to set an offset as a percentage of the input’s full scale range so
that this offset will be applied to the analog input signal.
P-40
168 ✓ rw Speed display scaling factor 0.00
0.00 - 6.00
Enables users to program the frequency inverter in such a way that an
alternative output unit, scaled from the output frequency or speed, will
be shown (e.g. for showing a conveyor belt's speed in meters per
second). This function will be disabled if P-40 = 0.00.
P-41
169 ✓ rw 0.0 - 30.0 PI controller proportional gain 1.0
Higher values will result in a larger change to the frequency inverter
output frequency as a response to small changes in the feedback
signal. An excessively high value can cause instability.
P-42 170 ✓ rw 0.0 - 30.0 s PI controller integral time 1.0
PI controller integral time. Higher values will result in a more damped
response for systems in which the overall process responds slowly.
P-43
171 ✓ rw 0 PI controller action 0
Higher values will result in a more damped response for systems in
which the overall process responds slowly.
direct operation
1 Reverse action
P-44
172 ✓ rw 0 PI setpoint source selection 0
Used to select the source for the PI setpoint value.
Digital, preset setpoint value (P-45)
1 Analog input 1
P-45 173 ✓ rw Digital setpoint value PI 0.0
0.0 - 100.0 %
If P-44 = 0, this parameter will set the preset digital setpoint value used
for the PI controller.
P-46
174 ✓ rw PI feedback source selection 1
0 Analog input 2
1 Analog input 1
2 Motor current
PNU
ID Access rights Value Description DS
RUN ro/rw
To Next Page
Loading...
