Eaton DF6100 - Shop Monitor Unit Wiring (MSU840)

100 INSTALLATION AND OPERATION MANUAL 25-16328-B November 2020 www.eaton.com
Section 4: Appendix
Shop monitor unit wiring (MSU840)
Installation
1. Separate the two halves of the unit
2. Drill out (or knock out) the required cable entries in the surface mounting back
- box
3. Fit the back-box in position and pass the wires into it
4. Connect the unit according to the diagram below
ote: N No addressing of the interface is required. See control panel
operation for details
Standard connections
ote: N
1. This unit can only be used with CDB300/I detector base and compatible detectors
2. Only connect cable screen to its adjacent earth terminal
3. The end of line resistor must always be fitted, even if the spur is unused
4. Maximum spur length - See BS5839 Pt1:2002 for Zone Coverage
5. Maximum number of call points allowed is unlimited
6. Detector zone end of line device is EOLM-1
7. Callpoint zone has end of line resistor
EE
LLOOOOPP
OOUUTT
IINN
CCAALLLL
PPOOIINNTT
ZZOONNEE
DDEETTEECCTTOORR ZZOONNEE
SSOOUUNNDDEERR
EEXXTTEERRNNAALL
PPSSUU
MMOONNIITTOORR
2244VV
EEXXTTEERRNNAALL
PPSSUU
IINNPPUUTT
11
22
FFIIRREE
RREELLAAYY
EE
EE EE
EE
EE
NN//OO
FFaauulltt
CCoonnttaacctt
NN//OO
2244VV DDCC OOUUTTPPUUTT
PPOOWWEERR SSUUPPPPLLYY UUNNIITT
2244VV
OO//PP
CC
NN//CC
--
--
-- --
++
++
++ ++
+
++
--
--
++
++
+
+
++
--
--
--
--
-- OOUUTT ++
-- IINN ++
-- OOUUTT ++
-- IINN ++
66KK88
1122KK
1122KK
12K
EEOOLLMM--11
Analogue Addressable Loop
Callpoints can be connected with detectors
on detector zone if preferred