106 INSTALLATION AND OPERATION MANUAL 25-16328-B November 2020 www.eaton.com
Section 4: Appendix
Micro output module wiring
(MCOM, MCOM-R, MCOM-S)
Installation
1. Fit the box in position using the mounting details below
2. Connect the unit according to the diagram below
3. Recommended Loop Cable Type: FIRETUF, FP200, MICC
ote: N
No addressing of the interface is required. See control panel operation for details.
There are no serviceable parts so no maintenance procedures apply.
Standard connections
ote: N
1. Only connect cable screen to its adjacent earth terminal
2. Output relay are volt-free contacts and are not monitored
IN +
Loop In+
Loop In-
Earth
Loop Out+
Loop Out-
Earth
IN -
EARTH
INPUT
LOOP
MCOM
To Next Page
Loading...
