44 INSTALLATION AND OPERATION MANUAL 25-16328-B November 2020 www.eaton.com
Section 3: Panel controls & indicators
Weekly test
To activate the touch screen, touch the top left corner of the screen until the screen
illuminates. To enter the supervisor mode touch the supervisor button and enter the
passcode. Select the others tab as shown below. Press Weekly test.
Weekly test is now in progress.
The panel will automatically return to the system healthy screen once the weekly
test has been completed.
Supervisor
FRE Off
Evacuate
Silence
Alarms
Mute
Buzzer
Reset
Fires
AC = 0
View Pre
Alarms
View
Disabled
View
Faults
Others
Weekly Test
Send Log to PC
Enable/Disable
View Log
Check Config
Print
Send analogue values to PC
Lamp test
Feature is outside EN54 Spec
Weekly test
Do you want to continue?
Weekly test
Awaiting Alarm Signal
Will reset after 4 minutes
Cancel
No
Yes
To Next Page
Loading...
