143
EA(B)O-6X06 01/2018 Rev. 1 4. Electro-Hydraulic Control Unit
Electro-Hydraulic Control Unit
Disassembly and Assembly
5. Remove the lters.
0036-18
0035-18
0034-18
Assembly
1. Mount the o’ring in its seat on the housing (arrow),
lubricate the o’rings of the electrovalve with its own oil
and install the electrovalve.
ATTENTION! In the assembly use all the
parts provided in the repair kit. Start with
the lters and then the o’rings.
NOTES:
The solenoid valves are dierent and each one have
a correct mounting position.
• The letter “P” at the beginning of the identication
(yellow arrows) means “PRESSURE” and are
mounted in the middle seats (orange arrows).
• The letter “Q” means “FLOW” and are mounted
on the end seats (blue arrows).
NOTE: Make sure that the snap-in boss between the
plastic body and the metal cover faces the inside of
the Electro-Hydraulic Unit (see detail).
To Next Page
Loading...
