145
EA(B)O-6X06 01/2018 Rev. 1 4. Electro-Hydraulic Control Unit
Electro-Hydraulic Control Unit
Disassembly and Assembly
0040-18
0041-18
4. Loosen the other three screws.
0042-18
0043-18
Assembly
1. To mount the new reservoir, place the two o’rings into
the coupling nozzles, lightly lubricate the o’rings with its
own oil and t the reservoir equally.
2. Complete the assembly following the reverse order of
dismantling, respecting the specied torque.
3. Complete the oil level following the manufacturer
instructions.
5. Remove the reservoir in the arow direction.
NOTE: When removing the reservoir, observe that
the o-rings are in the reservoir nozzles, otherwise
remove them from their housings.
To Next Page
Loading...
