155
EA(B)O-6X06 01/2018 Rev. 1 4. Electro-Hydraulic Control Unit
Electro-Hydraulic Control Unit
Disassembly and Assembly
0108-18
0110-18
0111-18
Assembly
1. For a better understanding, see the simulation of repair
set correct sequence, as if inside the chamber.
0109-18
3. Continue pushing the piston until extract it completely.
4. With the help of a extractor hook remove the two o’ring
and the xed gasket.
CAUTION! Make sure the correct
positioning of the xed gasket, which
should have the largest diameter on inside
(see detail).
CAUTION! Be careful when mounting
the xed gasket and o’rings, which are
installed in the cylinder. There is an
oil return channel between them (see
arrow) that NEVER may be obstructed by
improper mounting of one of the seals.
To Next Page
Loading...
