159
EA(B)O-6X06 01/2018 Rev. 1 4. Electro-Hydraulic Control Unit
Electro-Hydraulic Control Unit
Disassembly and Assembly
0120-18
0121-18
Recirculation Hose Replacement
Disassembly
1. To remove the recirculation, rst remove the oil reservoir
(see Reservoir Replacement), positioning a container to
prevent oil from dripping from the engine compartment.
2. Then remove the hose together with the clamps.
Assembly
1. Mount the new repair kit and, with the aid of a specic
pliers crave new clamps.
2. Mount the reservoir (see Reservoir Replacement).
Clutch Actuator Tube Replacement
Disassembly
1. Loosen the tube connection with a xed wrench and cut
the plastic clamp, removing the entire tube.
NOTE: Before replacing the actuator tube, seal
the reservoir cap to prevent from oil splashes (see
Preparation Before Disassembly, operations 3 and
4).
To Next Page
Loading...
