12
1. General Information 01/2018 Rev. 1 EA(B)O-6X06
Item Description Torque N.m (Lb.ft) Remarks
Electro-Hydraulic Control Unit
2B Screw 12-14 (9-10) Apply Loctite 262 onto thread
2D M8 x 25 Torx screw 19-26 (14-19)
2G M8 x 1.25 x 25 Screw 19-26 (14-19)
3 Control unit - Valve block
Apply Dow Corning 780 sealant
onto the contact face with the
transmission case
4 Maximum pressure valve 36-44 (27-32)
6 Pressure sensor 14-16 (10-12)
9 M5 x 13.5 Flanged screw 3.5-3.7 (2.6-2.8)
12 350 cc Pressure accumulator 141-159 (104-117)
14 Recirculation breather lter 28-32 (20-23)
23 Electrical motor screw 4.5-6.5 (3.3-4.8)
26 Reservoir cover 2.5-4.5 (1.8-3.3)
35 Hydraulic pump screw 5.4-5.6 (4.0-4.2)
37 Repair kit - Clutch actuator tube 18-20 (13-15)
42 Valve screw 3.5-3.7 (2.6-2.8)
45 Selection chamber cover screw 9-11 (6-8)
51 M8 x 30 Screw 29-35 (21-25)
54 M6 x 1.0 x 14 Screw 12-15 (9-11)
59 Screw 12-14 (9-10)
62 M5 x 0.8 x 10 Screw 12-15 (9-11)
64 M8 x 1.25 x 20 Screw 19-26 (14-19)
Shift Yokes and Rails
82 M8 x 18.5 Torx Screw 38-44 (28-32) Apply Loctite 262 onto thread
102 M14 x 1.5 Plug 19-26 (14-19) Apply Loctite 262 onto thread
Tightening Torques and Sealants
The correct application of adhesives (threadlockers) and sealing compounds (sealants) is important to assure
a proper assembly and to avoid leakages.
Tightening capscrews, plugs and nuts to the proper torque is important to prevent them from loosening and to
avoid oil leakage, assuring a long transmission life. Additionally, apply the recommended adhesive to the threads.
CAUTION! Always use a torque wrench to tighten fastenings to the specied torque.
The following table presents tightening torque and sealant recommendation for the transmission fastening
elements and components.
In the table, the item number corresponds to the number of the component in the exploded views included in
this manual. Please refer to the exploded views to identify the item in the table.
To Next Page
Loading...
