149
EA(B)O-6X06 01/2018 Rev. 1 4. Electro-Hydraulic Control Unit
0055-18
0056-18
2. Remove the pump, together with the gasket and pres-
sure ring.
0057-18
0058-18
2. Position the pump on the casing, guiding the shaft
coupling in the plastic coupling sleeve,ensuring that
the gasket and the pressure ring do not get out of their
seats.
3. Insert the two bolts and apply the specied torque.
Assembly
1. Fit the plastic coupling sleeve to the motor shaft.
NOTE: Check the condition of the plastic coupling
sleeve (see detail) for cracks, marks and / or wear,
as the jammed pump can damage it.
Electro-Hydraulic Control Unit
Disassembly and Assembly
To Next Page
Loading...
