Eaton EAO-6206A - Air Purge of Brushless Motor Chamber

160
4. Electro-Hydraulic Control Unit 01/2018 Rev. 1 EA(B)O-6X06
Electro-Hydraulic Control Unit
Disassembly and Assembly
0122-18
Assembly
1. Assemble the new actuator tube repair assembly, tapping
lightly to the end but not giving the nal tightening.
2. Install the plastic clamp observing the tube alignment.
3. Apply the specied torque.
0123-18
Air Purge of Brushless Motor Chamber
If all the oil in the system has been exhausted after the sup-
ply, it will be necessary to purge the conned air in the motor
chamber, following the steps below:
1. Fill the reservoir with oil to the maximum level.
0124-18