Eaton EDR-5000 - Page 972

EDR-5000 IM02602007E
Name Description
ZI.ExBlo TripCmd-I Module Input State: External Blocking of the Trip Command
SOTF.Active Signal: Active
SOTF.ExBlo Signal: External Blocking
SOTF.Rvs Blo Signal: Reverse Blocking
SOTF.enabled Signal: Switch Onto Fault enabled. This Signal can be used to modify Overcurrent Protection Settings.
SOTF.AR Blo Signal: Blocked by AR
SOTF.I< Signal: No Load Current.
SOTF.ExBlo1-I Module Input State: External Blocking
SOTF.ExBlo2-I Module Input State: External Blocking
SOTF.Rvs Blo-I Module Input State: Reverse Blocking
SOTF.Ext SOTF-I Module Input State: External Switch Onto Fault Alarm
CLPU.Active Signal: Active
CLPU.ExBlo Signal: External Blocking
CLPU.Rvs Blo Signal: Reverse Blocking
CLPU.enabled Signal: Cold Load enabled
CLPU.detected Signal: Cold Load detected
CLPU.AR Blo Signal: Blocked by AR
CLPU.I< Signal: No Load Current.
CLPU.Load Inrush Signal: Load Inrush
CLPU.Settle Time Signal: Settle Time
CLPU.ExBlo1-I Module Input State: External Blocking
CLPU.ExBlo2-I Module Input State: External Blocking
CLPU.Rvs Blo-I Module Input State: Reverse Blocking
ExP[1].Active Signal: Active
ExP[1].ExBlo Signal: External Blocking
ExP[1].Blo TripCmd Signal: Trip Command blocked
ExP[1].ExBlo TripCmd Signal: External Blocking of the Trip Command
ExP[1].Alarm Signal: Alarm
ExP[1].Trip Signal: Trip
ExP[1].TripCmd Signal: Trip Command
ExP[1].ExBlo1-I Module Input State: External Blocking1
ExP[1].ExBlo2-I Module Input State: External Blocking2
ExP[1].ExBlo TripCmd-I Module Input State: External Blocking of the Trip Command
ExP[1].Alarm-I Module Input State: Alarm
ExP[1].Trip-I Module Input State: Trip
ExP[2].Active Signal: Active
ExP[2].ExBlo Signal: External Blocking
www.eaton.com 972