104
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Input Shaft Disassembly/Assembly | Disassembly/Assembly TRSM0950
Procedure - Assembly
1. Place Clutch Housing in press with flywheel housing
side up.
NOTICE: Support the Clutch Housing to avoid damag-
ing the housing and sealing surface.
2. Place Input Shaft Bearing into Clutch Housing.
3. Place Input Shaft Bearing Removal and Installation
Tool (RR1075TR) and Universal Driver Handle
(OE8044-T0) onto Input Bearing.
4. Press Input Shaft Bearing into Clutch Housing.
NOTICE: Do not over press bearing into Clutch Hous-
ing. Over pressing could result in component damage.
5. Verify Input Shaft Bearing is fully seated in Clutch
Housing.
6. Place Clutch Housing in press with Flywheel Housing
side of the Clutch Housing down on Input Shaft Stand
(RR1073TR), supporting the Inner Bearing Race of the
Input Shaft Bearing.
NOTICE: Support the Inner Bearing Race to avoid dam-
aging the Input Bearing in the Clutch Housing.
To Next Page
Loading...
