110
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Main Housing Disassembly/Assembly | Disassembly/Assembly TRSM0950
10. Place Main Housing vertically in press and support
housing on the Oil Pump Assembly surface.
11. Place Input Shaft Bearing Removal and Installation
Tool (RR1075TR) and Universal Driver Handle
(OE8044-T0) onto Main Shaft Bearing.
12. Press Main Shaft Bearing out of Main Housing.
NOTICE: Support the Main Housing to avoid damaging
the housing and sealing surface.
13. Place Main Housing vertically in press and support
housing on Oil Pump Assembly surface.
14. Place Countershaft Bearing Installer (RR1076TR) and
Universal Driver Handle (OE8044-T0) onto Rear Lower
Countershaft Bearing.
15. Press Rear Lower Countershaft Bearing out of Main
Housing.
NOTICE: Support the Main Housing to avoid damaging
the housing and sealing surface.
To Next Page
Loading...
