2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
111
TRSM0950 Disassembly/Assembly | Main Housing Disassembly/Assembly
Procedure - Assembly
1. Install Main Housing in press vertically with the Main
and Clutch Housing mating surface down.
NOTICE: Ensure Main Housing is sitting flat on sealing
surface to avoid damaging the housing.
2. Place Main Shaft Bearing into Main Housing.
3. Place Main Shaft Bearing Installer (RR1077TR) and
Universal Driver Handle (OE8044-T0) onto Main Shaft
Bearing.
4. Press Main Shaft Bearing into Main Housing.
NOTICE: Support the Main Housing to avoid damaging
the housing and sealing surface.
NOTICE: Do not over press bearing into Main Housing.
Over pressing could result in component damage.
5. Verify Main Shaft Bearing is fully seated into housing.
6. Inspect Rear Lower Countershaft Bearing and verify
snap ring is fully seated in groove.
7. Place Rear Lower Countershaft Bearing into Main
Housing.
8. Place Countershaft Bearing Installer (RR1076TR) and
Universal Driver Handle (OE8044-T0) onto Rear Lower
Countershaft Bearing.
To Next Page
Loading...
